When using a ribbon mixer, there are steps to follow to produce mixing effects of materials.
Here are the ribbon mixer factory guidelines:
Every item was carefully examined and tested before being dispatched. Nevertheless, the parts might come loose and wear out during transit. Please make sure all parts are in place and the machine can operate correctly by looking over the machine's surface and the exterior packing when it arrives.
1. Fixing footed glass or casters. The machine should be placed on a level surface.
2. Confirm that the power and air supply are in line with the needs.
Note: Make sure the machine is well-grounded. The electric cabinet has a ground wire, but because the casters are insulated, only one ground wire is required to connect the caster to the ground.
3. Cleaning the mixing tank completely before to operation.
4. Switching the power on
5. 
Putting the main power switch on.
6. 
To open the power supply, rotate the emergency stop switch clockwise.
7. 
Checking whether the ribbon rotates by pressing the "ON" button.
The direction is correct, everything is normal.
8. Connecting air supply
9. Connecting air tube to 1 position
In general, 0.6 pressure is good, but if you need to adjust the air pressure, pull the 2 positions up to turn right or left.
10. Turning on the discharge switch to see if the discharge valve is working properly.
Here are the ribbon mixer factory operation steps:
1. Switch the power on
2. Switching the ON direction of the main power switch.
3. To turn on the power supply, rotate the emergency stop switch in a clockwise direction.
4. 
Timer setting for the mixing process.
(This is the mixing time, H: hours, M: minutes, S: seconds)
5. The mixing will begin when the "ON" button is pressed, and it will end automatically when the timer is reached.
6. 
Pressing the discharge switch in the "on" position. (The mixing motor can be started during this procedure to make it easier to discharge the materials out of the bottom.)
7. When the mixing is finished, turn off the discharge switch to close the pneumatic valve.
8. We recommend feeding batch by batch after the mixer has started for products with a high density (greater than 0.8g/cm3). If it begins after a full load, it may cause the motor to burn down.
Perhaps, this will provide you with some tips on how to operate the ribbon mixer.
Post time: May-25-2024